I have just installed a Unity 4.0 with Platform Specific disks. I want to enable Network Fault Tolerance on the two NIC cards. The install guide suggests to refer to documentation provided by NIC manufacturer. Do I have to update the driver to get this function? Any help would be appreciated.
Re: Unity 4.0 on MCS7835 - Network Fault Tolerance
No, I used the the CD/DVDs that came with the Unity server. The platform specific CD is the one that installed the OS (from an image I believe). I think I can use the SmartStart CD and install the Compaq teaming software and achieve this function. Just seems that since that is the recommended method in the install guide, the necessary drivers and software would already be there.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...