UNITY 4.0 Voice Messaging to Unified Messaging Migration
I'm currently running a UNITY 4.0(1) application for Voice Messaging only and I want to migrate it to an Unified Messaging configuration. I haven't found any documents regarding this kind of procedure. Is it possible to reconfigure the unity installation or is it necessary to reinstall again UNITY?
Re: UNITY 4.0 Voice Messaging to Unified Messaging Migration
You can do a DiRT backup and then a restore into a new install (of the same version of Unity of course) in the UM enviorenemnt - if the mail aliases on the VM system match those on the UM system you're done. If not, you'll have to pull out the migrate subscriber data tool and push the Unity data off the newly created accounts (by the DiRT restore) onto the appropriate email accounts as necessary.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...