Re: Unity Connection 7 Mailbox for Annoucements Only
On the CM:
Create a CTI Route point with a number that is CFA to VM.
Create a call handler that has a schedule that has it be open 24/7. Put in the same extension the CTI route point in CM had.
Go to greetings and select the standard greeting.
Change "Callers hear" to "My personal greeting."
Change the "After greeting" to call handler. In the drop down box, select the exact same call handler you are currently working on. Set it "Go directly to greetings." This will create a loop so that the greeting plays over and over again.
This works all well and good, but you get the continual 'is not available' after your greeting in the loop. Secondly, it isn't very elegant for letting others set messages such as "the office is closed today due to bad weather" as you end up with "I'm sorry is not available...... I'm sorry is not available" and so forth.
You misinterupted the steps we provided. You are hearing the system default greeting because you recorded your greeting as the recorded name of the call handler. You need to choose Edit > Greetings from the menu and use the Standard greeting. Record a greeting and choose Use my personal greeting instead.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...