I have FXO line coming into the 2611 gateway which has call routing capabilities. Busy or unanswer calls will forward to Unity VoiceMail Main Greeting. I got it to work that far but when Unity announces "dial an extension any time...", I dial extension x5001 which is already created in Unity but it rings back the main operator instead of other IP phone at that extension. Am I missing something in Unity config ? Thanks for all suggestions.<br>Duc Vu<br><br><br>
You can either pin-down or isolate Unity to the problem by placing a call into Unity with an IP phone, and attemtping to transfer to x5001. Does it work? If so, the transfer problem when the caller is external (coming in over th FXO), is probably not a Unity problem.
Steve, I had followed your guidance to narrow down the problem. From an IP phone calling another IP phone and get Unity main greeting but still unable to reach the desired extension. So Unity can't forward calls for both PSTN and internal phones. Any idea ? Thanks. Duc
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.