New install Unity 2.46 B102. Event viewer reports the following error message when Unity tries to start.<br><br>Component Miu: Thread 0x00000053 had a Failure on Port 2 in Method CAvMiuTapiMonitor::SetDevConfig()<br><br>DESCRIPTION: TAPI lineSetDevConfig() failed with 0x80000049 (LINEERR_OPERATIONUNAVAIL).<br>DETAILS: <br> HLINE: 0x00902DE8<br> DevConfig Param: 0x03159EA8<br> DevConfig Size: 1476<br> TAPI DeviceID: 1<br> Service Provider: D41MT.TSP. <br><br>Sean Poure<br>NEC-Voice Engineering<br>Sr. Aplication Engineer<br>714 4846275<br>
Is this AD-120? Digital Integration with D/42's? Are the lines from the PBX plugged into (and working correctly) to the voice board? Does Unity (or AD-120) continue to load up properly after this error?
Yes the above is correct. However I have a line connected to the first port on the first card in the system and I get signal. I still get that error message. Do I need lines for all the port for this card to come up...In the event viewer other AV events come up ok.
Sean Poure NEC-Voice Engineering Sr. Aplication Engineer 714 4846275
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.