Need some help with regard to installing unity express 7.0.6. I have a 2801 with AIM-module on it. It is currently running version 2.3.2 as below:
CUE# show software versions
- Installer 2.2.1
- Thirdparty 2.3.2
- Bootloader (Primary) 2.1.2
- Infrastructure 2.3.4
- Global 2.3.4
- GPL Infrastructure 2.3.0
- Voice Mail 2.3.2
- Bootloader (Secondary) 2.1.2
- Core 2.3.4
- Auto Attendant 2.3.0
- British English 2.3.0
I am not upgrading it and want to do a fresh install.
I am using the command "software install clean url tftp://10.1.1.1/cue-vm-full-k9.nm-aim.7.0.6.prt1 username admin password cisco" to install it but keep getting the following error. I downloaded and tried version 7.0.1, 7.0.2 and 7.0.3 and still getting the same error
Recently had a 2801 that I had to upgrade the IOS. After doing so, lost the voicemail. the CME version and the CUE version should be the same. What version of the IOS on the 2801 are you running (CME is in the IOS)? Also, the AIM-CUE module is prettty much EOL/obsolete.
Also a very good document to use is-
Cisco Unified SCCP and SIP SRST
System Administrator Guide
March 15, 2013
Also the CME router is the tftp server for the CUE module. I had to move stuff from flash to tftp by using copy flash: tftp: for it to load correctly.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.