Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started.

New Member

Unity Greeting

Hi

When i set up in my voicemail profile an personal greeting (and speak some options, because i allow some CallerInput) after my personal message the Unity System talks some default words, how to configure that within Unity

3.1.3

I also checked that the After greeting option is set to take message !

how can i configure that, because this worked under version 2.4.6.135

Please provide me with the right settings

Thanks a lot

regards

Ing. Helmut Schranz

mii ag, lerchenfelder straße 2/203, a-1080 wien

tel: (+43) (0)1 4070587-1251, fax: (+43) (0)1 4070587-7125

mobile: (+43) (0)699 12826005

mailto:helmut.schranz@mii.at

http://www.mii.at

  • Other Collaboration Voice and Video Subjects
1 REPLY
Cisco Employee

Re: Unity Greeting

As for the "I'll record your message at the tone..." prompt, here's a post on that:

http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&CommCmd=MB%3Fcmd%3Ddisplay_location%26mode%3Dnew%26location%3D.ee83e4c

I'm unsure I understand what you're asing about the "take message" issue. That's the default setting for a subscriber's greeting, of course, but you can change it in the SA. Individual subscribers don't have control over this, it's an admin function that has to be edited in the SA console.

158
Views
0
Helpful
1
Replies