the MIU will initalize lines for each TAPI port found up to the maximum on the key (or two if no key is there). If you have no TAPI devices installed (i.e. the CM TSP or the Dialogic TSP) then you will have no ports available to configure when Unity comes up.
the TSP will only report devices back if it's hooked up to CM ports - you can't trick it into thinking there are ports there that are not (at least not easily). I'm unclear why you are trying to do this in the first place...
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...