I have configured message notification in Unity to call a users cell phone and prompt them to enter their user ID and password. Once they do this, they can check their voice mails. The problem is the system isn't accepting any key input when it prompts the user to enter their user ID. It just disconnects the call. What is causing this?
Can you tell me how you configured the Unity to prompt the mobile user to enter the user ID and password? I set up the message notification last week, from the Unity port status report, I can see that the Unity was calling the mobile number, but my mobile phone got nothing.
I use translation patterns. It is a little more time consuming to setup but it is a little bit more secure then modifying unity call routing rules. If you screw hose up you could be a candidate for toll bypass fraud.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.