We had a problem today, our Unity shut down for no obvious reason, the network card was disabled, nobody did any intervention on the server, we verified the port on the switch, no errors occured. No logs in the Unity in regards on the card disabled.
When you logged onto the unity server, the network card was marked as disabled? I highly doubt the software would have done it; a more likely explanation is that someone disabled it. Look through the System Event Logs in Event Viewer for Event id 8033 Browser. The browser has forced an election on network ......
This is when the network card went offline and you might be able to see if someone was logged on during that time.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...