I am having problems getting pager function to work for OutCalling Voicemail notification. When I configure the notification to a phone everything works just fine I get notified. When I set up the pager function this does not work. From status monitor I see the following messages:
I do not see where anything was sent. What else should I look at. I have manually call the pager number and it asked for you to enter area code and number.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.