Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Unity server with 2 nics and ip addresses

I want to know if Unity 4.0(2) supports two nics with different ip addresses. It currently has both active, but when i check the VM ports on the Call Manager, Unity has registered into CCM with the IP Address of the second NIC, which is non-routable. It actually sits on the same VLAN as the CCM using NIC1. Can i change the source address??

1 REPLY
Cisco Employee

Re: Unity server with 2 nics and ip addresses

The "Configuring Dual NICs in the Cisco Unity Server" section in the Installation guide should answer your question. Here's the link for 4.0(2)...

www.cisco.com/en/US/products/sw/voicesw/ps2237/products_installation_guide_chapter09186a00801507e9.html#1592700

Basically, you have three options...

1. Run a fault tolerant mode

2. Disable TCP/IP for the second NIC

3. Disable the second NIC in the BIOS

113
Views
0
Helpful
1
Replies
CreatePlease to create content