Hi. I have Call Manager 6.1 and will be changing all our 4 digit line numbers. I want to do this in bulk rather than have to change it on each phone. I have been trying the BAT with no success so I must be doing it wrong. What is the best way to change the line number on over 250 phones? The external mask also needs to change but that is all. Everything else stays the same.
Well, I know the NEW DN's and I have exported all of the current ones. I also know the MAC addresses of the phones from an export. I would like to just assign the new DN's to the existing phones and update them in bulk. Kind of like changing one by hand but I want to do this in bulk since I know the old DN, new DN and mac addresses.
I know that this is an old post and that the solution for CallManager 6.1 is to use BAT export ALL DETAILS option, delete phones, modify DNs in BAT, reimport using also ALL details. However, I would like to confirm if for CallManager 8.6 this is the only way also, or is there another way to do it in bulk for a large number of phones
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.