Often when I invoke a tool from the Tools Depot, I'm advised there's an updated version of the tool on the Web. I go there, and sure enough, there's a downloadable new tool. I've tried downloading and extracting the new tool into the folder occupied by the old tool, replacing existing files, but get the same "there's a new version..." message again when I fire up what I thought would be the new tool. Is there a clean way to periodically refresh the Tools Depot content?
You need to download the updated version off the web page and run the setup in there - don't extract files and copy them - the setups from the tools will automatically update the registry keys used by Tools Depot to point to the latest version.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...