Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Upgradation Of CRS from 3.0(1) to 3.0(2)

I have CRS 3.0(1) running in a production environment. I have to upgrade it to 3.0(2). Can I do the upgrade just without backing up any configurations. Will be all the configurations saved if I do the installation without saving anything.

2 REPLIES
Blue

Re: Upgradation Of CRS from 3.0(1) to 3.0(2)

If you are backing up your CallManager DB using STI you will be fine. Just run the CRS 3.0(2) and when asked point it towards your 3.0(1) profile.

New Member

Re: Upgradation Of CRS from 3.0(1) to 3.0(2)

Scott,

In 3.0(2), there is no DC Directory installation, so you have to point your Directory and Repository configuration to a valid LDAP, ie, CallManager DC Directory or similar. Provided that is available, then you should not have any problems.

Please check if your CallManager(s) already has a copy of your Repository and Directory first. To do this, on your CallManager servers, if you have been using DC Directory:

- Start, Programs, DC Directory Administrator, and login

- Expand the directory for 'CCN Apps' branch, open up 'configurations' and 'applicstions' branch, and make sure there the Directory and Repository Profile name you used are there.

95
Views
0
Helpful
2
Replies
CreatePlease to create content