10-28-2009 09:57 AM - edited 03-13-2019 06:43 PM
Hi, i cannot find information on how to make an upgrade from callmanager 6.1 using old servers to callmanager 7.1 with new 7835 servers.
Do anyone knows what is the process or can guide me with the link where lies the procedure. I wonder how do i upload the 6.1 configuration on the new 7.1 servers.
Thank you all for your time.
Thanks
Solved! Go to Solution.
10-28-2009 10:21 AM
Read this link for the procedure
Migrating from Cisco Unity 4.x or Later to Cisco Unity Connection 7.x
http://www.cisco.com/en/US/docs/voice_ip_comm/connection/7x/upgrade/guide/7xcucrug022.html
HTH
java
if this helps, please rate
10-28-2009 10:02 AM
There are only 2 ways to do this, and they're the same in any version
A) upgrade original system, take backup and restore on fresh install on new server
B) take backup from original system, install same version on new server, restore, then upgrade
HTH
java
if this helps, please rate
10-28-2009 10:17 AM
Hi java, also can you help me on how to make the upgrade from unity 4.x to unity connection 7.1 also on a new server.
Or maybe could you help me with the link where i can find this procedure?
Thanks a lot for your time.
10-28-2009 10:21 AM
Read this link for the procedure
Migrating from Cisco Unity 4.x or Later to Cisco Unity Connection 7.x
http://www.cisco.com/en/US/docs/voice_ip_comm/connection/7x/upgrade/guide/7xcucrug022.html
HTH
java
if this helps, please rate
03-25-2010 12:16 AM
If we choose option A: upgrade original system, take backup and restore on fresh install on new server
License file must be added before or after the backup on the new server?
03-25-2010 07:22 AM
You don't need to backup the new server, you need to restore on the new server.
You need to install the license after the restore is done.
Make sure you reach licensing@cisco.com for the rehosting
HTH
java
If this helps, please rate
www.cisco.com/go/pdihelpdesk
04-04-2010 05:11 AM
I have CUCM 7.1(3b)SU2 [7.1.3.32900-4]. It was upgrade from 7.1(3b) [7.1.3.30000-1] during installation. The subscriber has been added successfully but when I run Unified CM Cluster Overview Report it shows me a Unified CM Component Version mismatch for more than one component. In fact the mismatched component is not installed at all on the subscriber. This will affect the call process if I forced to IP phones to register on the subscriber.
Attached is the XML file for that report.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: