Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Upgrade ATA 188

I am trying to upgrade a 2.15 version of software running MGCP to run 2.15 sip with the ata186us.exe. My understanding is the zup file for 2.15 sip is

ata18x-v2-15-020927a-2.zup.

So I type the following command on my pc:

ata186us -h172.16.3.26 -d1 -any2 ata18x-v2-15-020927a.zup

I then see the following

Using Host with IP : 172.16.3.26 as upgrade server

This machine IP: 172.16.3.26

Upgrade Server Port: 8000

Data stream 0 port: 8500

image found: code -- ata186.itsp2.v2.15

Using dialpad of your telephone (attached to your ATA box),

press ATA button to go to main menu, and enter:

100#172*16*3*26*8000# (to upgrade code)

NOTE:

Pressing 123# will announce your code's version number.

You can later verify that you have upgraded your ATA box.

-------------------------------------------

This program runs continuously; Press <ctrl>-c to abort.

Upgrade server ready...

I then issue the dialpad commands and after awhile of waiting the phone says "Upgrade failed" Any reason why this wouldn't work. I can ping the ata188 so I know I can communicate with it.

1 REPLY
Community Member

Re: Upgrade ATA 188

whoops ignore this message I was typing the wrong ip address of the upgrade server.

333
Views
0
Helpful
1
Replies
CreatePlease to create content