Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Upgrade from 3.1.2c to 3.1.3a version doesnt show change

I upgraded my publisher from 3.1.2c to 3.1.3aSPD but the version of CM still shows it is a 3.1.2c box. When I went to re-install 3.1.3a it asks if I wanted to re-install, any ideas?

Also, when I did an upgrade on another CM, the STI backup utility disappeared and could not be re-installed, same versions as above, any ideas?

1 REPLY

Re: Upgrade from 3.1.2c to 3.1.3a version doesnt show change

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

95
Views
0
Helpful
1
Replies
CreatePlease to create content