It is a little more complicated than just running an upgrade file. If you are going to upgrade from CM 3.0 to CM 3.1, you will need to have CCO access and a contract that allows you to download the software. If you have the proper access to get the files, the FIRST thing that you will need to do is upgrade the operating system. There is a file in the cryptographic software section of the CallManager 3.1 area called win-OS-Upgrade.3-1-2spA.exe. (http://www.cisco.com/cgi-bin/tablebuild.pl/cmva-3des). This will give you the proper service pack and hotfixes. You may also need the BIOS upgrade, depending on your platform. Once you have upgraded the OS, you can then download and install the upgrade. Here is the URL for the upgrades. http://www.cisco.com/cgi-bin/tablebuild.pl/callmgr-31
Make sure that you download and READ the release notes prior to performing the upgrades!
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...