Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

uRgEnT

i have a transmission link via fibre-optic b/w two states carrying 8E1s.I'm trying to bundle them together using multilink ppp.Did all the config on the routers at both ends, when i did a show run on the multilink interface, its still shows that it is down, but the e1 controllers are up and running. If you need to look at the configs, i wouldnt mind sending them to you.

1 REPLY
New Member

Re: uRgEnT

Have you conifigured the following:

1.E1 controllers

2.Bandwidth on all Serial interfaces.

3.Virtual template and

4.Loopback interface.

Especially the virtual template and the loopback interface has to be configured with great care. Please refer to the following sample configuration for more details.

Sample Configuration - Inverse MUX Application using Multilink PPP

http://www.cisco.com/warp/customer/131/7.html

Check out for the following also :

Restrictions for the dialer max-link 1 Command and MPPP

http://www.cisco.com/warp/public/131/dialer-max-link.html

Hope this helps.

82
Views
0
Helpful
1
Replies
CreatePlease login to create content