Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

URL in CiscoIPPhoneInput

Hello,

I would like to access a protected URL over the CiscoIPPhoneInput. Within my Webbrowser this works by entering http://User:Passwort@192.168.10.59/names.nsf

When I use <URL>http://User:Passwort@192.168.10.59/names.nsf/firmen</URL> within my CiscoIPPhoneInput i get the following error message after hiting the Search Button: Host Not Found

I think the problem is the : or the @ within the URL. Must I escape these characters?

Regards

Lars Hendrichs

3 REPLIES
New Member

Re: URL in CiscoIPPhoneInput

To be honest it sounds like a bug to me. You shouldn’t have to use escape chars to make it work. Have you checked with TAC or the bug finding interface on Cisco’s website?

New Member

Re: URL in CiscoIPPhoneInput

The : and @ symbols within the URL are just a means to supply the username and password within the URL line, if you remove that portion of the address, you should be prompted for a username and password.

If you were to take out the user:passwort@ section of your URL it should then just prompt you for a username and password.

I use this function all the time to access FTP sites that dont prompt you for a login.

Regards

Joel Helgeson

New Member

Re: URL in CiscoIPPhoneInput

Helo Joel,

i understand the meaning of the : and the @!!!

I need them because my site prompts for a passwort. So you see i can not remove them!


My Problem is that this will work within a browser but not within the VoIP-Phone.

For a better understanding you can find my asp-file here: http://www.executor.net/firmen.asp

Regards
Lars Hendrichs

413
Views
0
Helpful
3
Replies
CreatePlease to create content