make sure you have entered the users name on the phone configuration it is down towards the bottom of the page. If the name is entered I would do a debug isdn q931 on the gateway and verify that the name is there. if it is I would say that it is a pbx issue.
I wasn't sending the name with the IP phones. NOw I can see the names when I place a call between two IP phones but not to a phone connected to the PBX. However the number is displayed but not the text. Do you know which field QSIG uses to send the name?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...