Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

username fullname command no available in CUE CLI

I am trying to configure users on a CUE version 2.1.2 via the command line. I do not have access to all of the username commands. I only have username create username phonenumber and username phonenumberE164. I do not have username fullname or username pin or username password. Is there anyway to get access to these commands in the CLI?

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: username fullname command no available in CUE CLI

The fullname PIN, etc commands are part of the EXEC mode. The Config mode only allows for phone number and E164 settings. Check to ensure you are at the proper command prompt. Also, see the following link for more information on these commands.

http://www.cisco.com/en/US/products/sw/voicesw/ps5520/products_administration_guide_chapter09186a00803ecc2d.html

Hope this helps.

Steve

2 REPLIES
Silver

Re: username fullname command no available in CUE CLI

The fullname PIN, etc commands are part of the EXEC mode. The Config mode only allows for phone number and E164 settings. Check to ensure you are at the proper command prompt. Also, see the following link for more information on these commands.

http://www.cisco.com/en/US/products/sw/voicesw/ps5520/products_administration_guide_chapter09186a00803ecc2d.html

Hope this helps.

Steve

New Member

Re: username fullname command no available in CUE CLI

That did it. I must have ready through the admin guide 100 times and missed the differences in mode. They really should be consistent with where you configure the module.

Thanks,

Allen

248
Views
0
Helpful
2
Replies
CreatePlease to create content