Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Using (2) 7914s - CCME

I have several 7960's with 1 each 7914 attached that have been working fine. I went to add a second 7914, first unplugging phone and 7914, then changing config to 'type 7960 addon 2 7914', then plugged the phone back in.

Now both 7914's are blank and all red lights, in spite of multiple phone resets and power cycling and combinations of both. If I change the config back to 'addon 1' and unplug the second 7914, everything is good. When I change the config back to 'addon 2' but second 7914 is still unplugged, first one is back to all red.

Any suggestions would be appreciated.

-Michael

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: Using (2) 7914s - CCME

Yeah, this is the correct syntax.

type 7960 addon 1 7914 2 7914

Thanks,

Craig

5 REPLIES
New Member

Re: Using (2) 7914s - CCME

I would verify that you have the phone loads. Do you have the 7914 load specified under the telephony-service?

(7960)

tftp-server flash:P00308000400.sbn

(7914)

tftp-server flash:S00105000100.sbn

telephony-service

load 7960-7940 P00308000400

load 7914 S00105000100

ephone 1

mac-address 001A.6D0E.83CE

type 7960 addon 1 7914 2 7914

You can run the show ephone command to verify the phone and modules have the right load.

show ephone phone-load

Hope that helps.

Craig

New Member

Re: Using (2) 7914s - CCME

So the proper syntax should be "type 7960 addon 1 7914 2 7914" as you have stated?

The syntax I am using is "type 7960 addon 2 7914"...

Thanks,

-Michael

New Member

Re: Using (2) 7914s - CCME

Yeah, this is the correct syntax.

type 7960 addon 1 7914 2 7914

Thanks,

Craig

Hall of Fame Super Red

Re: Using (2) 7914s - CCME

Hi Michael,

Craig is correct here! 5 points for this nice answer Craig. There is a good reference in this doc;

type phone-type [addon 1 module-type [2 module-type]]

Example:

Router(config-ephone)# type 7960 addon 1 7914 2 7914

http://www.cisco.com/en/US/products/sw/voicesw/ps4625/products_configuration_guide_chapter09186a00807e13a7.html

Hope this helps!

Rob

New Member

Re: Using (2) 7914s - CCME

Hi Craig, I just tried it out and you are correct, I was using the wrong statement. Thanks a lot for your help, wish they were all that easy!!

-Michael

167
Views
5
Helpful
5
Replies