Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Cisco Employee

Using a NM-1CT1 as a Voice Gateway Module for PRI and Call Manager

Is this supported? Small Single office. All running g711 codec. Software conferencing and a 2600 with a NM-1CT1 in it to accept the Carrier's PRI? I've always used the NM-HDV with the MFT-T1/PRI card and the DSP's in most of my installations because of transcoding/etc.. Is this required still in the senerio above?

Please advise.

2 REPLIES

Re: Using a NM-1CT1 as a Voice Gateway Module for PRI and Call M

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you, or there is no public information available at this time. If you don't get a suitable response to your post, you may wish to review our resources online at http://www.cisco.com/go/solutions. You may also contact our product information line at 1-800-553-NETS or a Cisco Systems Engineer at your local Cisco office or reseller. To locate your local Cisco representative, visit http://www.cisco.com/warp/public/687/Directory.shtml

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

New Member

Re: Using a NM-1CT1 as a Voice Gateway Module for PRI and Call M

A NM-1CT1/NM-1CT1-CSU supports ISDN data only. You will have to use the NM-HDV-1T1 for a voice application.

108
Views
0
Helpful
2
Replies
CreatePlease login to create content