I would like to use a multiplexer in front of a 26xx/36xx in order to interface to several PSTN FXO analog lines over a E1 with R2 signaling. The manufacturer of the multiplexer is very positive that their device will only work with AS5300, and that R2 will not work properly on the 26xx/36xx when connected to the mux. Anybody experiencing similar problems? Do I have to conclude that the multiplexer's R2 software is defective, or maybe the R2 settings should be (dramatically) changed on the two devices in order to make the application work?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.