Has anyone had success in getting CLID to show up on an IP phone with incoming calls on a FXO-M1? I've verified that my telco line is delivering CLID (Nortel DMS100), but my FXO-M1 running 12.2(7)on my 2620 is unable to pass it along to the IP phone. I can see the Calling Party showing up in hex format in debugs, but its not getting handled correctly. Also, can anyone direct me to a doc explaining debug output messages???
Re: using CLID with FX0-M1 terminating a Centrex line
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...