Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Values for Art

Dave ,

I noticed someone asked the question earlier.

What are the best values to setup for ART good calls bad calls very bad calls etc Jitter and obviously latency over 150ms is not the best. Jitter is Jitter right so if you experience a call with max jitter of 120 and Avg of 23 how do you guys at CISCO rate this call.

Is there a suggested model for this ?

I was speaking to a guy from intergrated research the makers of prognosis software for callmanager and he said he had read some good dodco regarding this topic

any ideas where I can find it ?

Thanks Dave 8-)

2 REPLIES
Silver

Re: Values for Art

Hi,

This might help...

Check out the document (same document as in the ART question below):

http://www.cisco.com/univercd/cc/td/doc/product/voice/sw_ap_to/admin/admin_rp/1_1_1/user_gd/artch2.htm#xtocid96840

It identifies the default QoS values that ART uses to classify a call (ie good, acceptable, fair, etc).

Another link that might help is:

http://www.cisco.com/warp/public/788/AVVID/cvmtelemate.html#measurevq

which has a decent section on voice quality.

-Aaron

New Member

Re: Values for Art

Thanks for the reply.

regards

Allan Wells

89
Views
0
Helpful
2
Replies
CreatePlease to create content