cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
252
Views
0
Helpful
1
Replies

Variable Length dial plan & Lucent Definity PBX

asarlo
Level 1
Level 1

Hello,

I have the following problem, and I don't know it is it a router or pbx problem. I have 2 1750-2V with 1 FXS and 1 E&M. I configure a variable

length dial plan for example :

dial-peer voice 7 pots

destination-pattern 9T

port 0/1

forward-digits 7

prefix ,,99,9

!

so I can dial 91900, or 96224242. If I dial 9 and then 7 digits it run OK, but with less digits no. I can see that the destination router receive the digits correctly, so I think that the router sends wrong digits to the PBX, or the PBX perhaps don't understand them. Do you have any idea ??

Thanks a lot for your help!

Regards, Anacelia

1 Reply 1

smahbub
Level 6
Level 6

I’d suggest getting the debugs and calling Cisco’s TAC. This would be hard to troubleshoot here.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: