Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VC's problems

my core networks is ATM mesh

in my headquarters has 10 virtual paths, in each Virtual path we have several VC,

now i use cisco 7206 with PA-FE-TX connect to the Nortel passport 6400 ATM platform,

6400 has 10 E1 connect to the ATM MESH,

the diagram is :

PBX---AS5300--(Eth)7206(PA-FE-TX)--(Eth)6400---10E1-----ATM MESH

my questions are:

(1)Can i assign VCs from 7206? does the module PA-FE-TX conflict

the vc ?

(2)maybe i need a ATM Module instead of the PA-FE-TX,so i can assign VCs

(3)how can i make the VOIP OVER ATM more feasible? any suggestion?

who can tell me ?thank you in advance

1 REPLY

Re: VC's problems

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you, or there is no public information available at this time. If you don't get a suitable response to your post, you may wish to review our resources at the online http://www.cisco.com/go/solutions. You may also contact our product information line at 1-800-553-NETS or a Cisco Systems Engineer at your local Cisco office or reseller. To locate your local Cisco representative, visit http://www.cisco.com/warp/public/687/Directory.shtml

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

104
Views
0
Helpful
1
Replies
CreatePlease login to create content