Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Very New please advise

Hello,

I am not sure if this is the right place to ask this but here go's.

I have a PIX 501 and want to open ports 3782,3783 TCP&UDP for sockets used by Roger Wilco.

would i use somthing like...

conduit permit tcp eq 3782 any any ?

conduit permit udp eq 3782 any any ?

please advise, i am very new and don't want to mess this up:)

Thank you,

Mark

1 REPLY
New Member

Re: Very New please advise

I would use:

conduit permit tcp range 3782 3783 any

any

conduit permit udp range 3782 3783 any

any

Instead of “any” you may want to be more specific as to which hosts you are allowing these connections to and from. Also, don’t forget to setup a static translation for the host that will be connected to from outside.

92
Views
0
Helpful
1
Replies
CreatePlease to create content