02-09-2007 09:02 AM - edited 03-13-2019 03:55 PM
Hi,
please note that my client have VG224 configured as MGCP gateway with CCM 4.13
currently analogue phones can transfer but in blind mode, could it be possible to do a consultative transfer.
in case yes, how to do it, i could not find any doc on the net.
if i need to change the mode from MGCP to SCCP, it would be no problem.
thanks
Solved! Go to Solution.
02-09-2007 06:55 PM
Hi Wissam,
According to this VG224 doc, Consult Transfer is supported with SCCP. Have a look;
http://www.cisco.com/en/US/products/hw/gatecont/ps2250/products_data_sheet09186a00801d87f6.html
Hope this helps!
Rob
02-09-2007 06:55 PM
Hi Wissam,
According to this VG224 doc, Consult Transfer is supported with SCCP. Have a look;
http://www.cisco.com/en/US/products/hw/gatecont/ps2250/products_data_sheet09186a00801d87f6.html
Hope this helps!
Rob
05-15-2007 11:10 PM
Hi
I have configured vg224 with the call manager with SCCP .but stil the call transfering is not working. when i press the flash (Hook flash ) it will not switch to transfering mode
09-15-2007 11:39 PM
Probably you should set "Maximum Number of Calls" to the value more than 1.
06-23-2008 12:56 PM
Hi,
I've configured 7 VG224 for SCCP, Max. Calls on CUCM5.1.2 ist set to 2, but Call transfer doesn't work. On my VG224 i have SW 12.4
06-25-2008 11:44 PM
The one more problem may be incorrect IOS.
In my network I use
vg224-i6k9s-mz.124-4.T2.bin or
vg224-i6k9s-mz.124-9.T.bin
10-22-2008 11:10 AM
Hi guys,
I was having this problem and it was solved setting "Maximum Number of Calls"! Thank's for the tip!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: