Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VG 224 Transfer

Hi,

please note that my client have VG224 configured as MGCP gateway with CCM 4.13

currently analogue phones can transfer but in blind mode, could it be possible to do a consultative transfer.

in case yes, how to do it, i could not find any doc on the net.

if i need to change the mode from MGCP to SCCP, it would be no problem.

thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Red

Re: VG 224 Transfer

Hi Wissam,

According to this VG224 doc, Consult Transfer is supported with SCCP. Have a look;

http://www.cisco.com/en/US/products/hw/gatecont/ps2250/products_data_sheet09186a00801d87f6.html

Hope this helps!

Rob

6 REPLIES
Hall of Fame Super Red

Re: VG 224 Transfer

Hi Wissam,

According to this VG224 doc, Consult Transfer is supported with SCCP. Have a look;

http://www.cisco.com/en/US/products/hw/gatecont/ps2250/products_data_sheet09186a00801d87f6.html

Hope this helps!

Rob

New Member

Re: VG 224 Transfer

Hi

I have configured vg224 with the call manager with SCCP .but stil the call transfering is not working. when i press the flash (Hook flash ) it will not switch to transfering mode

New Member

Re: VG 224 Transfer

Probably you should set "Maximum Number of Calls" to the value more than 1.

New Member

Re: VG 224 Transfer

Hi,

I've configured 7 VG224 for SCCP, Max. Calls on CUCM5.1.2 ist set to 2, but Call transfer doesn't work. On my VG224 i have SW 12.4

New Member

Re: VG 224 Transfer

The one more problem may be incorrect IOS.

In my network I use

vg224-i6k9s-mz.124-4.T2.bin or

vg224-i6k9s-mz.124-9.T.bin

New Member

Re: VG 224 Transfer

Hi guys,

I was having this problem and it was solved setting "Maximum Number of Calls"! Thank's for the tip!

403
Views
0
Helpful
6
Replies
CreatePlease login to create content