Just installed a VG200 with 2 port T1. T1 1/0 is going to a Nortel PBX and is set up as AMI, SF, and internal clocking. T1 1/1 is going to a Telco and is set up as AMI, SF, and line clocking. I'm getting slips on T1 1/0. I've swapped the T1's around and I get the same thing. I put them back, set T1 1/1 to clock source line primary, still no help. The Nortel guy says that his side is set to line, but he doesn't know how to set it as internal, so I have tried that. I haven't found any documentation on CCO that states that the T1 with line clocking would redistribute to the T1 with the internal clocking. Could anyone point me in the right direction?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...