Does anyone know of any other commands other then show voice dsp and looking for busy DSPs to see if were using the DSPFARM on the VG200 for conference calls?
We ehave Media Resource group and list applied to dev pool in CCM.
Also, when on conf call on the IP Phone display it saids "To Call Manager". When I do it on another AVVID system it saids "To Conference". Is there a difference between these two outputs or is this customizable (Global CCM setting)? Customer wants to confirm they are using the hardware conf resources and not software. They don't have the software one in the media group. They also can have 6 callers per conference, is this due to the VG200 or ?
The outputs of these commands would give you more info on how the DSPFARM is getting used.
You may use the Admin Serviceability tool to monitor the hardware and software conference resources in real time. While the tool is running, place a conference call from the IP Phone and see which resource is getting utilized.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...