Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VG200 for DOD lines

HI,

I have VG200 with HDV-E1 card.I m getting DOD line fom telco.Im just confused as to how to configure VG200 for the same.This DOD has alreday been tested with Avaya EPBX .In that ,the E1 is configured as CAS.Now what all parameters shuld be given in E1 card for the same.I would like to configure VG200 as H.323 gateway.The range which im getting from my telco is 5502200 to 5502299.

please help.

1 REPLY
Silver

Re: VG200 for DOD lines

I am not sure if you are looking for DID or DOD. I guess for DOD, just the appropriate route pattern through this gateway for those numbers would do.

If you actually meant it for DID, please refer to this URL on how to configure it http://www.cisco.com/warp/public/788/voip/direct_inward_dial.html

and to configure VG200 as a h323 g/w with CCM take a look at

http://www.cisco.com/warp/public/788/AVVID/config_h323_ccm.html

126
Views
0
Helpful
1
Replies
CreatePlease to create content