We are using a Vg200 with FXS to interface a pbx/intercom system with our ip phone system. This allows our pbx users to get an ouside line (make off-net calls). The setup worked correctly for a few hours. At that point the digital phones on the pbx system would get a fast busy when trying to dial out (via the vg200). The display on their phone would say "Trunk Unavailable." I tried doing a shut/noshut on the FXS ports, that did not fix it. I tried issuing a reload command to the vg200 and that did not fix it either. If I power down the vg200 and power it back on again the service works for about an hour or two. Any suggestions?
I experienced the exact issue with a VG200. We were using one FXS port to send an Analog signal to two seperate Paging Amps. The run to one amp was about 800 feet. The REN on the PA was less than .5. But the VG would crash after a couple of hours. I removed one line from from the FXS port and the system stayed up for a few days, then crashed. The second run is close to 400 feet. For a test, I removed all analog lines from the VG, plugged in an analog phone for two weeks. No crash.
I then ran a single analog pair to the TAM-B, then from there to a small paging amp (30w) all within 5 feet. From the small amp, I ran analog to the big amps.
You may want to minimize the run from the VG to the TAM-B (or Eqiv.) The VG is tough, but old, long, and tired copper runs will crash it.
Thanks Scott, for your reply. Actually, the intercom system that we are interfacing with is less than a few feet away from the VG200. The rj11 connections are less than 6-feet long. The IOS version is 12.2(2)XN, system is 12.1(1r). Do I need to do a firmware or IOS upgrade on this device? Thanks for your time.
You should be okay on your IOS. I am running 12.1(5)XM7early and 12.1(1r). Definately a curious situation. Can you try a diffrent port? Anything else on the FXS card? Does the RJ11 patch cable have only a single pair in the center?
I don't know what is causing the failure, but you should definitely move off of 12.2.2XN. That release was deferred due to many issues and replaced by 12.2.11T, and now 12.2.13T is out if you have enough flash. One of the issues with 12.2.2XN was with dsp problems, which could very well be accounting for your issue.
SIP traces provide key information in troubleshooting SIP Trunks, SIP
endpoints and other SIP related issues. Even though these traces are in
clear text, these texts can be gibberish unless you understand fully
what they mean. This document attempts to br...
Please find the attached HTML document, download and open it on your PC.
This provides an easy to use form where you simply answer a few
questions and it will render the proper jabber-config.xml file for you
to copy/paste. There is built in logic to verif...
CUCM Database Replication is an area in which Cisco customers and
partners have asked for more in-depth training in being able to properly
assess a replication problem and potentially resolve an issue without
involving TAC. This document discusses the bas...