Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

VG200 MGCP FXS ports to PBX , No Disconnect on FXS

VG200 MGCP FXS ports to PBX , No Disconnect on FXS

Are there any parameters that can be set on the FXS ports to ensure positive disconnect when you hang up

e.g. a 7940 dials an fxs DN, they ring no answer to an off premise PBX, when the 7940 hangs up, the FXs port is still Off Hook Idle. Thanks

1 REPLY

Re: VG200 MGCP FXS ports to PBX , No Disconnect on FXS

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

146
Views
0
Helpful
1
Replies
CreatePlease to create content