Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VG200 Question!!??

On a single VG 200 can you have both a

NM-HDV-2T1-48 Single-Port 48-Channel T1 Voice/Fax Network Module

And also Two VIC-2FXS Two-Port Voice/Fax Interface Cards in the Chassis? I have these in the slots but they do nto show up in the IOS...

All I see from a show hardware is this:

1 FastEthernet/IEEE 802.3 interface(s)

2 Channelized T1/PRI port(s)

1 REPLY
New Member

Re: VG200 Question!!??

Jeff,

The WIC slots on the VG200 are not supported for any card type - only voice cards in the NM slot will work.

Regards,

Justin

87
Views
0
Helpful
1
Replies
CreatePlease login to create content