Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

VG200 to VG200 connected to Westell questions

I have a setup where I have phones at one location connected to FXS ports on a VG200. They are calling a Westell phone bridge that is also connected to a VG200 via FXS ports. The call is accepted by the Westell box and is put on hold when the operator hits the access button to pick up the call. The music on hold is played. When the operator goes to connect the call to the conference the call is disconnected with a fast busy. Any ideas.

1 REPLY

Re: VG200 to VG200 connected to Westell questions

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

95
Views
0
Helpful
1
Replies