Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

VG200 will not register with CCM

VG200 (IOS ver 12.2) will not register with Cisco Call Manager 3.2

2 ACCEPTED SOLUTIONS

Accepted Solutions
New Member

Re: VG200 will not register with CCM

show ccm-manager on IOS gateway

check CM for registered ports

Make sure you use the hostname of the vg200 when setting up the MGCP gateway in callmanager not the IP address

This is a regular issue.

Though it might not be yours...

Check out the link

http://www.cisco.com/warp/public/788/AVVID/vg200_cfg.html

New Member

Re: VG200 will not register with CCM

If you do not configure the appropriate dial-peers with the application MGCPAPP pointing to every port, they will not register.

5 REPLIES
Cisco Employee

Re: VG200 will not register with CCM

Please provide a "sh run" and what does "sh ccm" on vg200 indicate?

New Member

Re: VG200 will not register with CCM

what type of gateway is this? Mgcp or h323

New Member

Re: VG200 will not register with CCM

show ccm-manager on IOS gateway

check CM for registered ports

Make sure you use the hostname of the vg200 when setting up the MGCP gateway in callmanager not the IP address

This is a regular issue.

Though it might not be yours...

Check out the link

http://www.cisco.com/warp/public/788/AVVID/vg200_cfg.html

New Member

Re: VG200 will not register with CCM

Make sure you use the FQDN. When you do a "show MGCP", make sure the domain name in the router and the name you are giving it in the CCM are identical.

New Member

Re: VG200 will not register with CCM

If you do not configure the appropriate dial-peers with the application MGCPAPP pointing to every port, they will not register.

99
Views
0
Helpful
5
Replies
CreatePlease to create content