Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VG224 conference

Hi,

I configured VG224(mgcp), but i am not able to do conference with analog phones. if i press flash button, call is transfering this is the problem i am facing can you please give me the solution on this matter

Regards

stn

1 REPLY
Hall of Fame Super Red

Re: VG224 conference

Hi Stn,

You would need to use SCCP for these features to work;

Check out Table 1 from this VG224 doc (show SCCP support for Conference);

http://www.cisco.com/en/US/products/hw/gatecont/ps2250/products_data_sheet09186a00801d87f6.html

Conference Call

Initiates a three-party conference.

During an active call, user presses hookflash for dial tone, dials a third party, and then presses hookflash again to connect all three parties

From this doc;

http://www.cisco.com/en/US/products/ps6441/products_feature_guide09186a0080483a76.html#wp1178205

Hope this helps!

Rob

PS: How did you make out with the DST Emergency? I did respond to one of your posts but I never heard back to see if your issue was resolved :)

927
Views
0
Helpful
1
Replies