Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

at
New Member

VG224 & Modems/SCCP

hi,

following configuration:

--- pstn ---- 2811 ----- CCM ---- VG224 --- Modem/Fax

we try to configure VG224 with fax and modem support - does anybody successfully installed this - if possible with skinny protocol / or MGCP

(config , which version)

regards

alex

2 REPLIES
New Member

Re: VG224 & Modems/SCCP

I am no expert by no means, but we are using a similar set up. Here are some configuration recommenadations I recieved that have worked. Hope they work for you as well;

The important commands to configure fax passthrough are:

conf t

mgcp modem passthrough mode nse

mgcp modem passthrough codec g7llulaw

exit

you should also disable fax relay with:

config t

no ccm-manager fax protocol cisco

exit

Here is a link to some more:

http://www.cisco.com/en/US/partner/products/ps6441/

Re: VG224 & Modems/SCCP

So with VG248 and VG224, we have to configure the analog ports of what they are used for? For instance.. does it matter if the analog port is used as a modem line or a fax line?

Thanks!

504
Views
0
Helpful
2
Replies
CreatePlease login to create content