Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VG248 & Call Manager 3.1(3a)

Hi everybody

I'm facing some difficulties to connect one VG248 to an Call Manager 3.1(3a).

In the firmware page of the Call Manager doesn't appear any information related to the VG248.

I doubt that this version of Call Manager supports VG248!

I can't see the VG248, but it pings the CM.

VG248

Software version : 1.1(2)

Loader version : 1.0(1)

Thanks in advance

2 REPLIES
New Member

Re: VG248 & Call Manager 3.1(3a)

Call Manager sees the VG248 as VGC Phones. In the configuration of the VG248 under the telephony settings there is a value for CallManager device name (VGC0653d6b2dc). You use this value minus the VGC plus the port number on the VG248 for the mac address of new VGC phones in call manager.

Example

port 30 has a analog phone connected to it

the VG248 CallManager device name is VGC0653d6b2dc

in call manager create a new VGC phone

for the macaddress you would use

0653d6b2dc30

New Member

Re: VG248 & Call Manager 3.1(3a)

Hi,

The issue on Call Manager, the device name is vgc000653d6b561 and on VG248 the Call Manager name is VGC0653d6b561

The status on the Call Manager Administration is Not found, and no IP address.

But I do can ping the VG248 from the Call Manager.

If I do like to explained to do, the result is the same, no vgc065d6b56130 found, and no ip.

Thanks in advance for the help

MP

82
Views
0
Helpful
2
Replies
CreatePlease to create content