Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

VG248 MSG waiting indicator not working with Unity VM

We have a VG248 connected to call manager 3.3 and Unity 4.O.. Calls to the VG248 ports connect as expected to Unity, but MSG waiting indicator or stutter does not activate even though programmed in CM. MSG waiting works fine on the IP sets. What am I missing here? Thanks for any suggestions...

2 REPLIES
Cisco Employee

Re: VG248 MSG waiting indicator not working with Unity VM

That's not going to work.

This is the config supported

CCM <--> TSP <--> UNITY

CCM <--> VG248 <--> LegacyVM system

New Member

Re: VG248 MSG waiting indicator not working with Unity VM

I found the problem,,, Call Manager was not setting the port for message waiting lamp/stutter... I had to telnet into the VG248 and set the port. Now it works,,,

104
Views
0
Helpful
2
Replies
CreatePlease to create content