I have an Iridium satellite phone that has an anlog port off the back off the modem. If call comes in on the sat, the analog phone plugged into will ring. I was thinking that I could plug the analog port of the sat modem to an anlog port on the VG248. Create a DID on the port and then a shared line appeearance on an IP phone in the building.
Would this work? I'm basically taking the incoming analog as a trunk (i guess) and having it ring on an IP phone?
I have a 1MB I was going to test with it to mimick the Satellite analog.
- Create VG248 Port 1 with DID 5001
- punch down the analog pair from the satellite modem to the VG248 Port 1
- DID 5001, shared line on a 7940 IP phone.
Any thing wrong with this? Or will I get "dualing" or colliding dial tones?
I think you will have the wrong interface on the VG248 to plug into the satellite phone - right now the phone plugs into the port that is giving it dial tone when it goes off hook, so the satellite phone is acting like an fxs port - the vg248 is also an fxs port - so you can plug an analog phone into it, but the satellite phone is acting like a phone line, and you need to plug a phone line into an FXO port. I hope that makes some sense...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...