You will have to use H.323 for the analog DID function, discussed in the doc on CM DID support:
DID Supported Solutions
Cisco CallManager supports DID on three types of circuits:
Analog VIC-DID (two- or four-port hardware configuration)For the configuration and dial restrictions of this card, refer to Understanding Direct Inward Dial (DID) Voice Interface Cards. Remember that all past and current versions of Cisco CallManager only support these cards when the gateway uses H.323 signaling.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.