Does anyone know if this card will work on a 3640? According to the spec sheet it is supported on the ICS 7750 but no mention of other platforms. I could really use this card. It can handle 4 DID lines and also supports analog caller ID.
I think the only platform it's supported on is the ICS7750 MRP blades. The NM-2V that you would normally put it on in a 2600 or 3600 hasn't got enough DSPs to handle the 4-line VICs, only 2-line VICs, and it isn't expandable. It's supported on the 7750 platform because it's backed by more DSPs in the form of PVDM modules.
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...