Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

VIC2-2BRI + Alcatel Omni PCX Office 100 = Outbound call problem

Hello,

I'm not able to place an outbound call with a Cisco 1760 connected to an Alcatel Omni PCX office 100 with a VIC2-2BRI card.

Here is the Q931 log :

*Mar 6 04:02:59.623: %LINK-3-UPDOWN: Interface BRI3/0, changed state to up

*Mar 6 04:02:59.691: ISDN BR3/0 Q931: Applying typeplan for sw-type 0x1 is 0x0 0x0, Called num 0854

*Mar 6 04:02:59.727: %ISDN-6-LAYER2UP: Layer 2 for Interface BR3/0, TEI 90 changed to up

*Mar 6 04:02:59.735: ISDN BR3/0 Q931: TX -> SETUP pd = 8 callref = 0x18

Bearer Capability i = 0x8090A2

Standard = CCITT

Transer Capability = Speech

Transfer Mode = Circuit

Transfer Rate = 64 kbit/s

Channel ID i = 0x81

Called Party Number i = 0x80, '0854'

Plan:Unknown, Type:Unknown

*Mar 6 04:02:59.803: ISDN BR3/0 Q931: RX <- RELEASE_COMP pd = 8 callref = 0x98

Cause i = 0x81E4 - Invalid information element contents

*Mar 6 04:03:04.912: %ISDN-6-LAYER2DOWN: Layer 2 for Interface BR3/0, TEI 90 changed to down

*Mar 6 04:03:05.460: ISDN BR3/0 Q931: L3_ShutDown: Shutting down ISDN Layer 3

*Mar 6 04:03:05.512: %LINK-3-UPDOWN: Interface BRI3/0, changed state to down

What is the error : "Invalid information element contents" ?

1 REPLY
Community Member

Re: VIC2-2BRI + Alcatel Omni PCX Office 100 = Outbound call prob

For this error message there is a bug: CSCea49606

135
Views
0
Helpful
1
Replies
CreatePlease to create content