Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

VIC2-2BRI-NT/TE

Can someone please tell me if the VIC2-2BRI-NT/TE card requires and external NT1 in the US, or does it connect to a "U" interface?

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Red

Re: VIC2-2BRI-NT/TE

Hi Robert,

You will need the NT1. Have a look at this excerpt from a good cisco doc;

"The physical pinouts of the VIC-2BRI-NT/TE and VIC-2BRI-S/T cards are designed such that they will interface to an ISDN network directly through the external NT1 device. In this case, the cabling between the BRI port RJ45 socket and the ISDN NT1 would be a straight through (1 to 1) Category 5 cable."

From this good doc;

http://www.cisco.com/en/US/tech/tk652/tk653/technologies_configuration_example09186a008010ef6c.shtml#hw

Hope this helps!

Rob

Please remember to rate helpful posts.....

2 REPLIES
Hall of Fame Super Red

Re: VIC2-2BRI-NT/TE

Hi Robert,

You will need the NT1. Have a look at this excerpt from a good cisco doc;

"The physical pinouts of the VIC-2BRI-NT/TE and VIC-2BRI-S/T cards are designed such that they will interface to an ISDN network directly through the external NT1 device. In this case, the cabling between the BRI port RJ45 socket and the ISDN NT1 would be a straight through (1 to 1) Category 5 cable."

From this good doc;

http://www.cisco.com/en/US/tech/tk652/tk653/technologies_configuration_example09186a008010ef6c.shtml#hw

Hope this helps!

Rob

Please remember to rate helpful posts.....

New Member

Re: VIC2-2BRI-NT/TE

That's what I thought, but wanted to make sure.

Thanks for the quick reply.

352
Views
0
Helpful
2
Replies